Simple methods for applying embroidered patches to skin

By in
No comments

Embroidered spots can be dated to ancient Asian civilizations; for centuries. However, not until recently they could be placed in the garment using a hot iron and heat activated glue. With today's patches, you can easily apply them to most fabrics without needing a needle and thread. Fortunately, if you are able to place them with strong iron, it means that your fingers will not hurt and much easier and faster. The only problem is that you do not have to place ironware on the skin – at least in the traditional sense

High temperatures are not suitable for the skin

If crocheted spots are fastened, put the glue on the back until you reach the semi-liquid, sticky state. This requires great heat; is a heat that can damage the skin's sensitive surface.

It is true that the skin is very durable, but the surface is seriously damaged by concentrated heat sources. This is two problems. The first problem is that when the skin is damaged, the adhesive will not stick to it and the patch will fall. And if the patch falls, the skin gets an ugly signal where the iron burns. The same can be said of vinyl and various types of faux leather. Another thing to consider is that even if you find a way to stick the adhesive, a slider of iron that connects the bare skin remains burning signal. That is why you should never have a hot iron anywhere near the skin.

Is there another way?

We used to say that you can not use iron to put embroidered patches on the skin in the traditional sense. The reason for this is because it does not try to place iron on the skin in the conventional way, but there is a non-conventional method. This means that it can be used with special glue together with unheated iron. Yeah, cold iron. It is important to use iron as a press.

In order for this to work properly, you must have a special adhesive; the skin generation is hard to handle, so you will not be able to use any old adhesive. This special glue can be found in handicraft stores, sewing shops, and some other high-end leather goods specials. Be sure to read the instructions on the bottle carefully, taking care to specifically mention the use of leather products. Failure to do so may mean that you only waste your money.

The glue should be applied on the back of the patch according to the instructions on the bottle and then carefully place the patch on the skin where you want it. The next thing you have to do is use the cold iron to squeeze the patch firmly on time as it is on the glue bottle. Then release the iron and wait for the glue to dry. It's imperative to find out where you want the patch before it stops it. It will have a rough spot when it removes the patch after it has been placed on the skin.

Source by sbobet th

Leave a Reply

Your email address will not be published. Required fields are marked *